I have a "replacement" server in our chain that I used to replace a flakey server.
The original system was set up prior to the purchase of Endpoint Manger, and was on an older platform. Now the box is performing well but with the end point manager I cannot seem to find out why I cannot program the rest-api buttons via the endpoint manager. This is so on the D40 and the D70 templates.
The pbx firmware is 6.12.665.29 service pack 1.0.0.0 .. endpoint 12.0.0.78
and to the best of my knowledge, all modules are fully up to date... Yup I did buy the endpoint and the rest of the 15 yr pack.
any pointers would be helpful.
Fred